Frequently asked questions about projection screens, projectors and home cinema chairs.


Synchronizing the radio trigger PRO

On the right side of the screen case next to the power supply, there is a small circular opening. A small yellow adjustment pin is included with the trigger PRO. Other thin items, such as the tip of a paper clip, work as well. 

To synchronize the screen it must be connected to the power supply; since the trigger has a built-in battery for this purpose, it is not necessary to plug it into the trigger output of the projector. 

Now, press the pin into the above-mentioned opening of the screen until you hear a switch that is hidden behind it click. Once you hear the click, the screen will be in synchronization mode for approx. 10 seconds. 

Use this time to press the same pin in the opening in the center of the back of the trigger. Again, you will hear the pressure point of the switch.

Now the synchronization process is completed and once you have plugged the trigger into the trigger output of the projector, the screen will drop and raise itself automatically when the projector is switched on or off.

Important: Check your projector menu to see whether the trigger output is enabled.

Answer not found?
Use our contact form to ask us your question to the contact form